[hilly]

Just had an update from Marc at DSP on how to use the Stardust powder properly !!!



Using STARDUST as Skin Powder

Note: For the first usage, apply Stardust only to the arms or legs in order to be certain you do not have an allergic reaction, never use the powder without deluting it first with water!!.

Try not to swallow or to breathe it in, even in powder form. Make sure you have a timer or a clock available before you start this process. It is important that you do not leave the Stardust on the skin for more than 2 minutes. Start out in the bath tub first with your head area and work downward always. If you take a shower, work from the opposite direction. Don’t use Stardust on open sores or freshly shaved areas etc. Take care that you do not get Stardust in your eyes, mouth, or on tender areas. If you do, flush immediately with water. Use Stardust more diluted on the genitals.

Use the amount of one teaspoon and the double amount of water, scoop the Stardust powder into your wet hands and rub them together. When the powder has dissolved, use both hands to rub (massage) the liquid into your wet skin areas (You may also use a sponge.), don`t worry about the smell it will fade away soon. As you apply Stardust, keep the mixture moving all over the body for a while to even out the concentration.

Usually after one minute you may feel an itching, stinging or light burning sensation on the skin. This is occurring because the fibers are reacting and popping. This is a good response! You may also dilute the Stardust with more water, if you find an area is burning excessively, use a lot of water on the area and wash it off even if you have not reached the 2 minutes mark. For those with extremely sensitive skin, you may dilute first 3-4 tablespoons in your bath tube for a light treatment, or dilute 2-3 tablespoons of Stardust in an 8 oz spray bottle and spray the area and rub it later with your hands into your skin.

When 2 minutes is up, wash off the mixture…if you are a few seconds over or under, it is okay. But too many minutes may cause skin irritations. It only takes a little to do the job. Afterwards, you may wash your skin with your regular soap however this is not necessary.

You will get the best results if you alternate the Stardust with the Body Wash Lotion. Both can and should be used all over the body. Approximately one teaspoon of the Stardust is enough for the scalp, ears and neck, or the backside and the shoulders and so on. Use daily or every second day the Body wash lotion and only once or twice a week the Stardust powder!. The stardust powder can be used also to treat single pimples or small areas at a time.

Both the Stardust and the Body Wash liquid will dry out the skin a bit, so it is a good idea to use a moisturizing lotion (coconut) after treatment, or DSP cream wich is excellent to sooth and lubricate the skin too. If you have a heavy reaction or more symptoms as before, try spacing your treatments further apart. More Skin Symptoms means also that more Fibers move and force themselves out…This is good! Your Skin will begin to heal as the Fibers are EXPELLED! 1 pound of DSP stardust is generally enough for 50-70 body wash applications.


Using Stardust as Laundry Powder


Add about 4-6 tablespoons (1.5 - 2 oz.) of Stardust to a full size washer load and soak the wash for 4-5 hours in the pre-wash cycle or even better over night. Mini washers may cut this amount in half, or soak in the sink first. Fill the wash machine only half full to have later a better rinse off effect of fiber remains and wash heavy infested cloth twice and wash also the inside out. After soaking, run your machine all the way through. Then follow your regular wash routine. It is recommended that you spray inside and wipe down your dryer prior to adding laundry.

Stardust can also be used to clean rugs, carpet, etc. Add about 2- 3 tablespoons fuls to an 8 oz spray bottle and spray thoroughly. The stardust powder has only a small bleaching effect, anyway, test please a small area first to ensure your fabrics will be maintained,. or reduce powder amount. Be sure to ventilate the room by opening windows. You should also leave the room while it is treating and drying. This can also be used effectively to remove fibers in your automobile carpeting. If possible complete by vacuuming up fibers. Good Luck...